Can't add address as part of start up (plus workaround)

Follow

Jon Waland

September 19, 2018 22:54

Firmware version - 4.0.925 (No updates)

Web UI Version - 1.8

Hardware revision - 3   Hardware - HD-16

 

Powered up to check all is ok (not installed yet) - ran through the setup process - got to address and entering anything had zero effect. No matter what I put in (full address, just "sydney", or "sydney, Australia", the screen stayed at the entry box.

 

workaround - use the android app. Or enter lat/long on local web

 

0

• 

  LeRoy Mattingly July 02, 2019 22:09

  I have same problem. And I don't have an Android for and Android app. I can't find any place on the local web to enter lat/long.

  Suggestions?

   

  0

  Comment actions Permalink
• 

  RainMachine Nicholas July 07, 2019 08:34

  If you go to http://RAINMACHINE_IP_ADDRESS with a browser from a computer on same network with RainMachine it will open the Web Interface. 

  On Web Interface you can go to Setting > Systems and you will see Location and Timezone. Set the Location First hit Apply and then the TimeZone.

  0

  Comment actions Permalink
• 

  LeRoy Mattingly July 07, 2019 10:31

  Did that. There is no "Location and Timezone" option on the Systems Settings page. 

  Only have the following:

  • Device Name
  • Date and Time
  • Units
  • Admin Password
  • Reset to Default
  • Master Valve

  0

  Comment actions Permalink
• 

  RainMachine Nicholas July 07, 2019 17:00

  You probably have a 1st Gen RainMachine, if you have problem setting up the location you will need to contact support and send the device to us for update.

  0

  Comment actions Permalink

Please sign in to leave a comment.